AirMesh 1031 (0017)¶

4.0.2 - 2024-06-25¶

• MT protocol version 1.10

Fixed¶

• The MT message was not dequeued if it failed to send due to an error.

4.0.0 - 2023-12-14¶

• MT protocol version: 1.9

Added¶

• Establishing connections faster

• New broadcast/multicast feature

• Firmware broadcast support

Changed¶

• Firmware download improvements

• Upstream queue improvements

Fixed¶

• Fixed bug that could cause the device to brick under certain conditions when aborting firmware upgrade.

Removed¶

• Property support

  • 0x8123 - Start Firmware Update with Model Number

  • 0x9001 - Antenna Type

  • 0x8006 - Production Info

  • 0x8020 - Power Source

3.0.0 - 2022-11-01¶

• MT protocol version: 1.5

Added¶

• Firmware update timeout will only apply during download. If the firmware image is downloaded within given timeout, the timeout will set to zero and the device will wait for a new image to apply.

• Added property:

  • 0x8160 - Ping Counter

Changed¶

• Removed 0x8101 - Uptime reporting. It is now read-only.

Fixed¶

• Reading property 91.00 - Uplink RSSI value returned 0

2.1.0 - 2021-12-15¶

• MT protocol version: 1.1

Added¶

• Added event:

  • 0x8113 - Watchdog Reset

Changed¶

• Used software reset instead of watchdog reset for radio off event in storage and also network data (device status) successful notification in connected mode.

2.0.0 - 2021-04-27¶

• MT Protocol Version: 1.1

Added¶

• 3 more priority level i.e. system, system high, critical

• Logic to resend critical priority message on reconnect (with same route) if it seems lost due to disconnection.

• Handled critical priority message lost scenario - disconnected the uplink - and flushed uplink queues.

Changed¶

• Improved uplink queue for better traffic utilization

Fixed¶

• Fixed heartbeat periodic reporting issue. It was reported only once on joining the network.

• Fixed traffic priority in uplink

[1.1.1] - 2021-02-06¶

Fixed¶

• Property 0x9010 - Default Pins State were not applicable

1.1.0 - 2021-02-02¶

Added¶

• Report internal error (0x0030) on write request in case of writable and null property.

• Support of property not applicable (0x0026) status code

• 10ms delay in connect heartbeat to delay it from application packet.

• Logic to re-request firmware block early (in some cases) instead of waiting for 30 second.

Changed¶

• Allow multiple bits in key.

• In multiple bit compare result of key, consider highest AND-result value. Also the RSSI is above the threshold value.

• Allow to set Scan window between 15% - 95%. It was 5% - 95% before. If value < 15 already stored in flash, Set to 15%.

• Minimum possible value for heartbeat interval is 60 seconds instead of 1 second.

• Set 60ms delay between two dfu packet.

• Do not reset device on firmware update timeout.

Fixed¶

• Device stop scanning between 5% - 11% scanning window setting.

• Fixed device type reporting

• Firmware update fixes

1.0.0 - 2020-10-30¶

Initial release.