Compulab IOT-GATE-IMX8PLUS 2031¶

Description¶

Compulab IOT-GATE-IMX8PLUS 2031 is a gateway host. To work as a gateway for the Meshtech BLE network it needs to be paired with a USB BLE adapter, for example a Raytac MDBT50Q-RX 0040.

This hardware is sourced from Compulab. See Compulab IOT-GATE-IMX8PLUS for hardware details.

Configuration and monitoring of the gateway is available through Meshtech Device Management Portal.

• Firmware Model Number: 0x2031

• Downlinks: Up to 18

Normal Operation Procedure¶

Start by inserting a Raytac MDBT50Q-RX 0040 into the USB port. Use the USB port on the back, furthest toward the edge:

Make sure Raytac MDBT50Q-RX 0040 is not already configured. If you are unsure, you can always perform a factory reset of Raytac MDBT50Q-RX 0040 first. Apply power (PoE support in ETH2) by PoE or 12V power plug. Device need to get IP/network settings by DHCP on the ETH2 ethernet port. If properly configured and able to reach the internet (MQTT with TLS port 8883, and DNS query) it will provision itself towards iot.meshtech.no. There you can log in, claim, activate and configure it. Raytac MDBT50Q-RX 0040 BLE MAC address will be used as gateway’s ID. Use gateway ID or Compulab IOT-GATE-IMX8PLUS serial number for claiming.

LED Indication¶

There are two LEDs on the front side of the device; LED 1 and LED 2.

Properties¶

Measurements¶

Events¶

Variants¶

Root Certificates Management¶

Additional root certificates (in PEM format) can be added using 0x8030 - Add Root Certificate or removed using 0x8031 - Remove Root Certificate.
The current set of additional root certificates can be read using 0x8032 - Root Certificates and 0x8033 - Root Certificate Fingerprints.

Root Certificates are needed for accessing HTTPS endpoints that present a certificate not signed by an official trusted certificate authority (CA).

History¶

Release Notes¶

Licenses¶